Screw pair for injection screw pump

To buy wholesale Screw pair for injection screw pump from Titanium, contact the supplier via the messenger, request a callback or call the phone number.

DescriptionSpecifications
Screw pair for injection screw pump
Price per pcs
125.39125.39USD$
Minimum order
1 pcs
Quantity
Total
125.39$
Titanium

St Petersburg

Manufacturer
  • questionIcon
Other products from this supplier
Similar products
Description

Screw pair Titanium-4 for injection screw pump Titanium-706, Titanium-Profi, similar screw pumps and plastering stations. In stock. Delivery to any city of the Russian Federation. Specifications Works with micro-cement, cement, CPS, plaster, etc. It works with fractions up to 2.5-3.0 mm The resource of 10 - 20,000 kg for dry material on micro-cements and similar materials, on CPS and mixtures with fillers with a fraction of 1.2mm - 2.5mm, the resource is less. The resource directly depends on the following parameters: the fraction of the pumped solution, the height and range of the solution supply, the number of bends in the hose, and the diameter of the hose. It operates on a right-hand rotation (left rotation is only for assembly) Operating speed - no more than 400 rpm Stator diameter – 48 mm, flange diameter - 51 mm, stator length – 210 mm Rotor – slot connection To save the life of the screw pair, follow the operating rules. do not exceed the maximum fraction size of 2.5mm-3.0 mm. do not exceed the operating speed of 400 rpm Do not apply the wrong lubricant during assembly, only silicone spray lubricant. Do not allow stones, self-tapping screws, or metal shavings to enter the screw pair through the pump hopper. clean the hopper and the pump line regularly, particles of solidified solution can damage the screw pair. when storing the pump for a long time, remove the screw pair, store it disassembled, with silicone grease applied. During prolonged storage on the pump in assembled form, the elastic material of the stator is deformed, as a result, the tension in the rotor-stator joint is reduced. Assembly of the screw pair before assembling a new screw pair, be sure to spray silicone grease (spray) inside from both ends of the new stator and onto the screw of the new rotor. By rotating the rotor to the left (counterclockwise), screw the rotor into the stator until the lower section of the stator and the end of the rotor coincide. The upper part of the stator, the rotor inlet, has a conical cutout, the lower part of the stator is flat. It is forbidden to clamp the stator in a vice during assembly, as it may change shape. To assemble, fix the rotor and screw the stator onto it. To facilitate assembly, especially at low air temperatures, it is recommended to heat the stator of the screw pair on the fan heater.

Specifications
  • Manufacturer's article number

    Титан-4

  • Brand / TM.

    Титан