Hydraulic Bulldozer

Description

Crawler hydraulic bulldozer, very detailed radio-controlled model. Designed specifically for heavy conditions of transportation of gravel, sand, asphalt, snow, wood chips or stones. Made of 100% aluminum (except caterpillar and hydraulic pump made of steel), fully assembled and ready to work! The welded bucket is made of steel Fully painted(yellow powder coating) Steel hydraulic system(brushless system) Operator's workplace in scale (the figure of the driver and the seat can fit) Length: 685 meters / 68.5 cm Width: 351 mm / 35.1 cm Height: 323 mm / 32.3 cm Weight: 20 kg Maximum force on the bucket (at the bottom): 76 kg / 167 lbs Maximum force on the bucket (top): 50 kg / 110 lbs Maximum bucket force (thrust): 50 kg / 110 lbs Driving speed: 408 meters per hour Bucket Height: 6.87 inches / 174.6mm Maximum lifting and lowering angle of the bucket: 29 degrees Maximum bucket tilt angle (left and right): 9 degrees Maximum ripper depth in the ground: 1.97 inches Total mass load: 37 kg Maximum lifting capacity: 42 kg All-metal transmission (gear ratio 1:256) This product is professionally pre-assembled Notes: Do not use more than Lipo 3S batteries. (11.1 volts(s)) As soon as the hydraulic cylinder (dump truck) reaches the maximum height, do not push further. Before starting the ESC, you must turn on the transmitter. ESC supports XT60 connector Before starting, we recommend checking the fastening connections of the equipment Use high-quality hex screwdrivers to avoid cutting off the screw heads. Use the thread retainer when screwing metal screws into metal parts. Do not tighten the screws too much, otherwise the thread may be torn off. The axle hubs can be unscrewed, but pliers with nylon tips may be required if they are tightened very tightly.